Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações na iPod Nano 4th/5th Generation Hold/Lock Switch Ribbon Cable Repair Introdução

Edição por Pete Green

Aguardando aprovação

Antes
Depois
Sem alteração
dispositivo
[ ]iPod Nano 5th Generation
Type
[ ]repair
Thing
[ ]Hold/Lock Switch Ribbon Cable
Title
[ ]Repairing iPod Nano 5th Generation Hold/Lock Switch Ribbon Cable
Introduction
[ ]I have tried a few repair methods concerning this cable and have given it much thought. The first, and obvious one, was soldering but I found that I was beaten by surface tension. Working with stuff so small surface tension becomes a huge force and just throws the two components apart. In the end I did the job with silver conductive paint, which, would you believe, has the oppposite effect.
Time Required Min
Nenhuma estimativa
Time Required Max
Nenhuma estimativa
Imageid
Antes
Depois
Difficulty
Moderate
Conclusion
[ ]To reassemble your device, follow these instructions in reverse order.
Author
Public
Não
Summary
[ ]Most of us have been there. The first big headache you encounter when opening up a 4th or 5th generation Nano is the hold switch cable. I'ts about 1mm wide, has a sharp right angle bend in it and only a little bit stronger than a piece of bathroom tissue.

Sinalizadores

  • In Progress added.
  • Member-Contributed Guide added.

Passos

Step #: 1
Antes
Depois
Step #: 2
Antes
Depois
Step #: 3
Antes
Depois
Step #: 4
Antes
Depois