Ir para o conteúdo principal

Alterações na iPad 2 Wi-Fi EMC 2560 Front Panel Adhesive Strips Replacement Introdução

Edição por Andrew Optimus Goldheart

Edição aprovada por Andrew Optimus Goldheart

Antes
Depois
Sem alteração
Introduction
Use this guide to replace the adhesive on your iPad to seal the deal on a repair-job well done.
Before you begin peeling and sticking tape, it's important to have clean adhesion surfaces on both the front panel and the rear case. Use a spudger to scrape off any large excess bits of original adhesive, then clean all of the gluing surfaces with a paper towel and rubbing alcohol or Goof Off.
It is recommended that you peel each adhesive strip as needed, rather than lay them out all at once.