Ir para o conteúdo principal

Alterações na Apple Watch Series 1 Force Touch Sensor Replacement Introdução

Edição por Tobias Isakeit

Edição aprovada por Tobias Isakeit

Antes
Depois
Sem alteração
dispositivo
Apple Watch Series 1
Type
replacement
Thing
Force Touch Sensor
Title
Apple Watch Series 1 Force Touch Sensor Replacement
Introduction
Unfortunately, opening up your Apple Watch may damage the Force Touch Sensor, which also serves as a gasketing seal. The sensor is made up of two layers, glued together. These layers may separate when you open your watch, compromising its seal after reassembly. If this happens, you'll need to repair or replace the sensor before reassembling your watch.
Be sure to follow our [guide|41083] guide when you're done.
Time Required Min
1 hora
Time Required Max
2 horas
Imageid
Antes
Depois
Difficulty
Difficult
Conclusion
To continue reassembling your device, follow our [guide|41083] guide.
Author
Public
Não
Summary
Replace or repair the Force Touch Sensor on your Apple Watch Series 1.

Pré-requisitos de Guia

Ferramentas

  • iOpener x1 added.
  • iFixit Opening Tool x1 added.
  • iFixit Opening Picks (Set of 6) x1 added.
  • Curved Razor Blade x1 added.
  • Tweezers x1 added.
  • 1.0 mm Flathead Screwdriver x1 added.
  • Tri-point Y000 Driver Bit x1 added.

Peças

  • Apple Watch (38 mm) Replacement Battery x1 added.
  • Apple Watch (42 mm, Original & Series 1) Replacement Battery x1 added.
  • Apple Watch Battery Connector Bracket x1 added.
  • Apple Watch (38 mm, Original & Series 1) Screen x1 added.
  • Apple Watch (42 mm, Original & Series 1) Screen x1 added.
  • Apple Watch (38 mm, Original & Series 1) Force Touch Sensor Adhesive Gasket x1 added.
  • Apple Watch (42 mm, Original & Series 1) Force Touch Sensor Adhesive Gasket x1 added.
  • Apple Watch (38 mm) Adhesive Strips x1 added.
  • Apple Watch (42 mm) Adhesive Strips x1 added.

Sinalizadores

  • In Progress added.