1. To remove the lens, three T15 x 12.5mm screws must be removed by a T15 head screwdriver. The location of the other two screws are marked in red.
    • To remove the lens, three T15 x 12.5mm screws must be removed by a T15 head screwdriver.

    • The location of the other two screws are marked in red.

  2. After the lens has been removed the back cover needs to be removed. There are no snaps or screws holding it in place. After the lens has been removed the back cover needs to be removed. There are no snaps or screws holding it in place. After the lens has been removed the back cover needs to be removed. There are no snaps or screws holding it in place.
    • After the lens has been removed the back cover needs to be removed. There are no snaps or screws holding it in place.

  3. Free shipping on all orders over US$100 or containing a Pro Tech Toolkit!

    Visite Nossa Loja
  4. Remove battery by unplugging it from the circuit board.
    • Remove battery by unplugging it from the circuit board.

  5. Remove the circuit board by pressing on the mounting clips (shown in red circles) using the spudger. Remove the circuit board by pressing on the mounting clips (shown in red circles) using the spudger.
    • Remove the circuit board by pressing on the mounting clips (shown in red circles) using the spudger.

  6. Desolder the wires to free the circuit board.
    • Desolder the wires to free the circuit board.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Jeremiah Rhoades

Member since: 07-11-2017

365 reputação

3 Guides authored

Equipe

IUPUI, Team S2-G3, Harley Fall 2017 Membro de IUPUI, Team S2-G3, Harley Fall 2017

IUPUI-HARLEY-F17S2G3

3 Membros

3 Guides authored

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 2

Últimos 30 dias: 9

Todo: 224