Yamaha YPG-225 Keys Replacement

Turn the keyboard over so that the keys are facing the ground.

Pop the tabs on the battery casing and remove it from the back plate.

Locate the six batteries and remove them from the battery cavity.

Remove the six 10mm screws at the top of the backplate.

Remove the seven 12mm screws in the middle of the back plate.

Remove the eight 10mm screws from the side and the bottom of the back plate.

Flip over the keyboard

Lifting from the front and the back of the face plate equally, pull the face plate up and then back, away from the keyboard.

• Be careful when removing the face plate. There are wires attached.

Remove the 32mm screws that hold keys down.

Remove the block of keys that holds the key you wish to install.

• To do this, apply a small force away from the top of the keys and slightly toward the floor.
• If done correctly, the block of keys will come to a slight downward angle.

Press the tab on the back side of the block of keys out and detach the black keys.

Remove the individual white key(s) or the black key set(s) that require replacement.