Pular para o conteúdo principal

Introdução

If the device does not start and the Sensor Lens is in good condition, then the Circuit Board may be faulty and need replacement.

  1. Begin by removing both screws and the brushed metal casing. Simply lift up at the indicated area with your hand. The INSTALL and REMOVE indicators may be incorrect, so exercise caution when removing the screws. The INSTALL and REMOVE indicators may be incorrect, so exercise caution when removing the screws.
    • Begin by removing both screws and the brushed metal casing. Simply lift up at the indicated area with your hand.

    • The INSTALL and REMOVE indicators may be incorrect, so exercise caution when removing the screws.

  2. Remove both 3/8" Ph2 screws attached to the grey belt at the top and bottom. Lift the grey belt away. This gives access to the server board.
    • Remove both 3/8" Ph2 screws attached to the grey belt at the top and bottom.

    • Lift the grey belt away. This gives access to the server board.

  3. Kit de Reparo de Bateria do MacBook

    A partir de $69.99

    Buy Now

    Kit de Reparo de Bateria do MacBook

    A partir de $69.99

    Buy Now
  4. Remove all three 1/2" Ph1 screws connecting the server board to the device. During reassembly, install the screws before reattaching the wires. During reassembly, install the screws before reattaching the wires.
    • Remove all three 1/2" Ph1 screws connecting the server board to the device.

    • During reassembly, install the screws before reattaching the wires.

  5. Use a plastic opening tool to remove the two pink capped wires in the upper left corner of the server board. Use the same tool to dislodge the white capped ribbon bus with the multi-colored wires. After these steps, the server board should easily come off the side of the device.
    • Use a plastic opening tool to remove the two pink capped wires in the upper left corner of the server board.

    • Use the same tool to dislodge the white capped ribbon bus with the multi-colored wires.

    • After these steps, the server board should easily come off the side of the device.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Blane Hirsh

Membro desde: 17-09-2018

255 reputação

2 Guias de autoria

Equipe

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 3

Todo: 63