Pular para o conteúdo principal

Introdução

If your blender is leaking or making strange noises, consider replacing the O-ring.

  1. Flip over the pitcher to expose the base of the blade assembly.
    • Flip over the pitcher to expose the base of the blade assembly.

    • Using the H4.0 Allen key from the 54 bit driver kit, attached to an impact driver, remove the socket head cap screw from the drive coupling.

    • Apply a solvent to remove adhesive if necessary.

  2. Using a pair of pliers, pull of the drive shaft coupling.
    • Using a pair of pliers, pull of the drive shaft coupling.

  3. Kit de Reparo de Bateria do MacBook

    A partir de $69.99

    Buy Now

    Kit de Reparo de Bateria do MacBook

    A partir de $69.99

    Buy Now
  4. Using a flat head screwdriver and a mallet, bend down the two tabs holding the large nut. Using a flat head screwdriver and a mallet, bend down the two tabs holding the large nut.
    • Using a flat head screwdriver and a mallet, bend down the two tabs holding the large nut.

  5. Remove the nut using a crescent wrench.
    • Remove the nut using a crescent wrench.

  6. Push the blade assembly into the jar.
    • Push the blade assembly into the jar.

    • Remove the blades from the device.

    • Be careful not to cut yourself when handling the blades.

  7. Use tweezers to pull off the o-ring. Be careful not to cut yourself while handling the blender blades.
    • Use tweezers to pull off the o-ring.

    • Be careful not to cut yourself while handling the blender blades.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Luke Kutz

Membro desde: 19-04-2018

342 reputação

3 Guias de autoria

Equipe

Cal Poly, Team S25-G16, Maness Spring 2018 Membro de Cal Poly, Team S25-G16, Maness Spring 2018

CPSU-MANESS-S18S25G16

4 Membros

5 Guias de autoria

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 1

Todo: 51