Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Peças e ferramentas

Introdução

If your blender does not operate, try opening it as per this guide and checking the wires on the control board. If that yields no results, consider replacing the board if possible.

  1. Flip the base of the blender upside-down. Remove the four 1/2" long screws in the corners of the base using a Phillips #2 screwdriver.
    • Flip the base of the blender upside-down.

    • Remove the four 1/2" long screws in the corners of the base using a Phillips #2 screwdriver.

  2. Using the metal spudger,  pry off one half of each rubber foot. Note that one side of the foot is glued down; pry off the other side.
    • Using the metal spudger, pry off one half of each rubber foot.

    • Note that one side of the foot is glued down; pry off the other side.

  3. Using the same screwdriver, remove the next four 1/2" long screws in the holes under the feet.
    • Using the same screwdriver, remove the next four 1/2" long screws in the holes under the feet.

    • Pull the base off of the blender.

  4. Kit de ferramentas básico para eletrônica

    Kit pequeno. Grandes possibilidades.

    Shop Toolkits

    Kit de ferramentas
    básico para
    eletrônica

    Shop Toolkits
  5. Pull off the plastic housing. Pull off the plastic housing.
    • Pull off the plastic housing.

  6. Using the same Phillips #2 screwdriver, remove the two 3/4" long screws holding the control board in place. Using the same Phillips #2 screwdriver, remove the two 3/4" long screws holding the control board in place.
    • Using the same Phillips #2 screwdriver, remove the two 3/4" long screws holding the control board in place.

  7. Using pliers, pull off all the connectors on the top. Using pliers, pull off all the connectors on the top.
    • Using pliers, pull off all the connectors on the top.

  8. Pull or pry off the last connector block, then remove the control board.
    • Pull or pry off the last connector block, then remove the control board.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Cole Gillespie

Membro desde: 19-04-2018

464 Reputação

2 Guias de autoria

Equipe

Cal Poly, Team S25-G16, Maness Spring 2018 Membro de Cal Poly, Team S25-G16, Maness Spring 2018

CPSU-MANESS-S18S25G16

4 Membros

5 Guias de autoria

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 1

Últimos 30 dias: 4

Duração total: 104