Introdução

Battery replacement is recommended every 300 charge cycles. Use this guide to replace the battery in your 6000 series Welch Allyn Connex Vital Signs Monitor.

PLEASE NOTE: This repair guide was developed by the iFixit team based on Welch Allyn's own service manual. Neither iFixit nor this repair guide is endorsed by or affiliated with Welch Allyn.

Unplug the AC power connection cable.
  • Unplug the AC power connection cable.

Adicionar comentário

Place your thumb and forefinger on the blood pressure (NIBP) hose connector. Squeeze the side tabs until the connector releases.
  • Place your thumb and forefinger on the blood pressure (NIBP) hose connector. Squeeze the side tabs until the connector releases.

    • Always grasp the hose by the connector. Do not pull on the hose itself.

  • Pull the connector away from the connector port.

Adicionar comentário

  • Place your thumb and forefinger on the Pulse oximetry (SpO2 or combined SpO2/SpHb) cable connector. Squeeze the side tabs until the connector releases.

    • Always grasp the cable by the connector. Do not pull on the cable itself.

  • Pull the connector away from the connector port.

Adicionar comentário

  • Grasp the temperature probe and pull it up to remove it from the monitor.

Adicionar comentário

  • Remove the cover of the temperature module by pressing the tab and sliding the cover to the right.

Adicionar comentário

  • Depress the spring tab on the temperature probe cable connector and withdraw it from the probe port.

Adicionar comentário

  • Remove the flathead screw on the USB networking door.

  • Loosen the captive Phillips #2 screw securing the monitor to the stand.

Adicionar comentário

  • Holding the monitor securely, open the USB networking door.

    • You may have to lift the monitor slightly to allow the door to swing out from the stand mount.

Adicionar comentário

  • Detach any accessory USB cables from USB ports on the monitor.

Adicionar comentário

  • Slide the monitor off of the stand tray.

Adicionar comentário

  • Place the monitor upside down on a clean surface.

  • Insert a coin into the slot and push to open.

    • Choose a coin that fits comfortably into the slot.

  • Remove the battery cover.

Adicionar comentário

  • Use the plastic label to remove the battery from its recess.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

4 outras pessoas concluíram este guia.

kyle2

Member since: 03-06-2010

101 reputação

Autoria de 1 guia

Equipe

Team Freedom Membro de Team Freedom

Community

1 Membro

1 Guide authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 3

Últimos 30 dias: 13

Todo: 923