Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Introdução

This guide will show you how to refill the dancing water speakers through the bottom water plug. These water speakers have a tendency to leak through the bottom water plug. This guide will show you step-by-step how to take the speakers apart so you can replace the water plug with super glue. The reason why we replace it with super glue is the glue works to seal the hole a lot more effectively and it's a simple process.

Peças

Nenhum componente especificado.

  1. You will need to have a clean work space, water dancing speakers, super glue, mineral water, and Phillips screw driver ready. Unplug the USB cable powering your speakers before you continue.
    • You will need to have a clean work space, water dancing speakers, super glue, mineral water, and Phillips screw driver ready.

    • Unplug the USB cable powering your speakers before you continue.

  2. Using the phillips screw driver remove the 4 screws seen on the back of speakers.
    • Using the phillips screw driver remove the 4 screws seen on the back of speakers.

  3. Once the four screws are taken out you will need to slide the bottom piece from the water canister.
    • Once the four screws are taken out you will need to slide the bottom piece from the water canister.

    • When the two are separated set the water canister bottom facing up.

  4. On the bottom of the water canister you will see a hole where the water was inserted. There will be a black plug covering the hole. Using your screw driver you can pry the plug out.
    • On the bottom of the water canister you will see a hole where the water was inserted. There will be a black plug covering the hole.

    • Using your screw driver you can pry the plug out.

    • Once the plug is taken out you can refill the speakers. Only refill the speakers with one inch of water.

  5. After the water is filled to approximately one inch. Super glue the hole shut and let dry.
    • After the water is filled to approximately one inch. Super glue the hole shut and let dry.

  6. When the glue is dry slide speaker back on to water canister.
    • When the glue is dry slide speaker back on to water canister.

    • Once they are put together place back panel on and insert the four screws.

    • repeat steps 2 through 6 on second speaker.

Conclusão

Your water dancing speakers are now ready for use. Thank you for using this guide.

40 outras pessoas concluíram este guia.

Andrew

Membro desde: 17/02/2015

1.157 Reputação

2 Guias de autoria

Equipe

Vegas Room H9 Membro de Vegas Room H9

Community

13 Membros

15 Guias de autoria

the pump is defective how to replace

anpicard@videotron.ca

andrepicard2012 - Responder

I couldnt get plug out either so I drilled a hole in back and filled it with mineral water and sealed it with a small strip of scotch tape and duct tape on top of that in case I had to get back in. It works, but now it looks different. Sometimes the water clings to the inside and it looks a little foggy. Is it mineral water, or mineral oil? If it leaks again I'll prob try the oil.

Lacepage - Responder

The original liquid has a lower surface tension than water. I used odorless mineral spirits.

If the pump is noisy, try a drop of oil in the motor.

aeromojito - Responder

My speakers keep spraying even though their is no music playing, is that a good thing?

Andrew - Responder

good it worked with me, thanks for guidance.

Shujath Shariff - Responder

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 17

Últimos 7 dias: 89

Últimos 30 dias: 500

Duração total: 154,040