Introdução

The power cord connects the clipper to a power supply. If the power cord wiring breaks due to repeated bending, the power cord may need replacement. Replacing a broken power cord makes sure the clippers receive the power needed to run the device.

Remove the two 5.0 mm JIS #1 screws to loosen the cutting blades.
  • Remove the two 5.0 mm JIS #1 screws to loosen the cutting blades.

  • Make sure your device is not connected to power before you begin.

Adicionar comentário

Lift the bottom blade straight up from the device body to remove it.
  • Lift the bottom blade straight up from the device body to remove it.

Adicionar comentário

Remove the three 9.0 mm JIS #1 screws attaching the base of the blade assembly to the body.
  • Remove the three 9.0 mm JIS #1 screws attaching the base of the blade assembly to the body.

Adicionar comentário

Lift the base of blade assembly straight up off of the body.
  • Lift the base of blade assembly straight up off of the body.

Adicionar comentário

Remove the two 12.0 mm JIS #1 screws on the back of the device body.
  • Remove the two 12.0 mm JIS #1 screws on the back of the device body.

Adicionar comentário

Remove the 13.0 mm Phillips #2 screw on the side of the device body.
  • Remove the 13.0 mm Phillips #2 screw on the side of the device body.

    • This screw is located on the opposite side of the body from the switch.

Adicionar comentário

Remove the spring  on the side of the body using tweezers.
  • Remove the spring on the side of the body using tweezers.

Adicionar comentário

Pry the body case off of the device using a spudger.
  • Pry the body case off of the device using a spudger.

Adicionar comentário

Remove one 7.5 mm JIS #1 screw from the switch base. Remove one 7.5 mm JIS #1 screw from the switch base.
  • Remove one 7.5 mm JIS #1 screw from the switch base.

Adicionar comentário

Unplug the cord terminal from the  motor connector.
  • Unplug the cord terminal from the motor connector.

Adicionar comentário

Remove the cord from the device base by pulling gently.
  • Remove the cord from the device base by pulling gently.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Manuel Salazar M.

Member since: 07-11-2017

101 reputação

Autoria de 1 guia

Equipe

IUPUI, Team S7-G3, Baechle Fall 2017 Membro de IUPUI, Team S7-G3, Baechle Fall 2017

IUPUI-BAECHLE-F17S7G3

3 Membros

4 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 3

Todo: 67