Ir para o conteúdo principal

Visual Land Prestige 7L Front Facing Camera Replacement

O que você precisa

  1. Visual Land Prestige 7L Front Facing Camera Replacement, Back Panel: passo 1, imagem 1 %32 Visual Land Prestige 7L Front Facing Camera Replacement, Back Panel: passo 1, imagem 2 %32
    • Remove the two 8mm Phillips Head screws located at the bottom of your device.

  2. Visual Land Prestige 7L Front Facing Camera Replacement: passo 2, imagem 1 %32 Visual Land Prestige 7L Front Facing Camera Replacement: passo 2, imagem 2 %32 Visual Land Prestige 7L Front Facing Camera Replacement: passo 2, imagem 3 %32
    • Insert the spudger between the two pieces of the case around the media ports and pry them apart.

    • We found the best way to get the spudger inside the case was to insert in into the SD card slot. Be sure to only insert the spudger a shallow amount and be careful not to damage any of the inside of the device.

    • Finish unsnapping each plastic piece holding the device together along the bottom.

  3. Visual Land Prestige 7L Front Facing Camera Replacement: passo 3, imagem 1 %32 Visual Land Prestige 7L Front Facing Camera Replacement: passo 3, imagem 2 %32 Visual Land Prestige 7L Front Facing Camera Replacement: passo 3, imagem 3 %32
    • Move the spudger down the rest of the case, separating each side, and finally the top.

    • Pull the back off and place it to the side.

    • Without a back panel for protection, be sure place your device on the table screen-side down to avoid damaging the internal circuitry.

  4. Visual Land Prestige 7L Front Facing Camera Replacement, Front Facing Camera: passo 4, imagem 1 %32 Visual Land Prestige 7L Front Facing Camera Replacement, Front Facing Camera: passo 4, imagem 2 %32
    • Remove the adhesive padding.

  5. Visual Land Prestige 7L Front Facing Camera Replacement: passo 5, imagem 1 %32 Visual Land Prestige 7L Front Facing Camera Replacement: passo 5, imagem 2 %32
    • Unclip the connector that attaches the camera to the motherboard.

    • For more information on unclipping connectors see this How To Guide

    • Do not pull on the camera until you're sure that it's unclipped, the gold connection will rip.

    • Gently pop the camera out of the connector and off the case.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Greg Azzalina

Membro desde: 01/28/15

263 Reputação

Autoria de 1 guia

Equipe

Penn State, Team 2-25, Kaschak Winter 2015 Membro de Penn State, Team 2-25, Kaschak Winter 2015

PSU-KASCHAK-W15S2G25

Membros da 4

Autoria de 4 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 1

Duração total: 273