VersaMed iVent 201 Power Pack Replacement

Introdução

This guide provides detailed steps on replacing your device’s power pack. For more information on replacing the power pack, please refer to page 144 in the service manual.

O que você precisa

Passo 1 Power Pack

VersaMed iVent 201 Power Pack Replacement, Power Pack: passo 1, imagem 1 %32

Remove the four 3mm x 20mm Phillips screws located on the corners of the power pack.

Editar

Passo 2

Pull the power pack from the compartment using black handle.

Editar

Passo 3

Remove the five 3mm x 10mm Phillips screws and washers from the back of the power pack. Lift off the cover after.

Editar

Passo 4

Turn the battery pack upside down and take the battery out of the casing.
When reassembling, listen for the sound of the cooling fan for confirmation that the connection was successful.

Editar

Passo 5

Remove the two spade connectors using pliers.
When assembling the power pack, MAKE SURE to connect the red wire to the positive terminal and the black wire to the negative terminal of the battery.

Editar

Conclusão

To reassemble your device, follow these instructions in reverse order. Caution: MAKE SURE THE RED WIRE IS CONNECTED TO THE POSITIVE TERMINAL AND THE BLACK WIRE IS CONNECTED TO THE NEGATIVE.