Conserte seus objetos Comunidade Loja

Unbranded UB-15MS10 Speaker Replacement

Guia arquivado
Este guia é mantido exclusivamente para fins históricos. Use a versão atualizada do guia para executar o reparo.

Introdução

This guide walks you through how to replace a broken speaker on your UnBranded Tablet.

O que você precisa

  1. Unbranded UB-15MS10 Speaker Replacement, Back Panel: passo 1, imagem 1 %32

    • Remove the cover over the Micro SD outlet by using a plastic opening tool to pry open and push out the cover panel.

    Editar

  2. Unbranded UB-15MS10 Speaker Replacement: passo 2, imagem 1 %32

    • Remove the two 4-mm #0 screws from the inside of the Micro SD compartment.

    Editar

  3. Unbranded UB-15MS10 Speaker Replacement: passo 3, imagem 1 %32 Unbranded UB-15MS10 Speaker Replacement: passo 3, imagem 2 %32

    • Insert blue guitar picks in the crease between the top and bottom panels starting on the same end as the Micro SD slot.

    • Inserting the picks directly under the Micro SD compartment was the easiest place to get started. It still requires some force.

    Editar

  5. Unbranded UB-15MS10 Speaker Replacement: passo 4, imagem 1 %32

    • Insert the black spudger between the guitar picks in order to pry open gaps between the blue guitar picks.

    • As the gaps open, slide the guitar picks along the sides to separate the panels.

    Editar

  6. Unbranded UB-15MS10 Speaker Replacement: passo 5, imagem 1 %32

    • Pry all four sides apart using the blue guitar picks and the black spudger until they can easily be pried apart by hand.

    Editar

  7. Unbranded UB-15MS10 Speaker Replacement, Speaker: passo 6, imagem 1 %32

    • Remove the yellow tape from the speaker.

    Editar

  8. Unbranded UB-15MS10 Speaker Replacement: passo 7, imagem 1 %32

    • Remove the two 4-mm #0 screws holding the speaker in place.

    • The copper-colored plastic piece covering the speaker does not need to be removed from the device, move it to the side to reach the screws.

    Editar

  9. Unbranded UB-15MS10 Speaker Replacement: passo 8, imagem 1 %32

    • Remove the silver tape covering the speaker's black and red wires.

    Editar

  10. Unbranded UB-15MS10 Speaker Replacement: passo 9, imagem 1 %32

    • Reflow the solder of the black and red wires from the circuit board by using the soldering iron.

    • For more information about using a soldering iron click here.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

com 7 outros contribuidores

Jordan Turk

Membro desde: 09/21/15

331 Reputação

Autoria de 2 guias

Emblemas: 10

+7 outros emblemas

Equipe

IUPUI, Team 2-1, Baechle Fall 2015 Membro de IUPUI, Team 2-1, Baechle Fall 2015

IUPUI-BAECHLE-F15S2G1

Membros da 3

Autoria de 3 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 8

Duração total: 728