Conserte seus objetos Comunidade Loja

ULCO ntegrus PSV ventilator Battery Replacement

Equipamento Médico
Nem o iFixit nem este guia de reparo são endossados ou afiliados ao fabricante do dispositivo médico.

Introdução

This guide will show you how to access and replace the battery of the ventilator.

Preparation to service:

  1. Make sure anaesthetic machine is OFF
  2. Disconnect the machine from power supply
  3. Gain access to ventilator housing from guide below





O que você precisa

    • Before disassembly, make sure the front wheel breaks are on.

    Editar

    • Make sure ALL gas supplies are disconnected and the system has been purged, and make sure all electrical supplies have been disconnected.

    Editar

  3. Editar

  4. ULCO ntegrus PSV ventilator Battery Replacement: passo 4, imagem 1 %32

    • With one hand on the ventilator removal handle and one holding the lower half of the ventilator, pull up firmly on the handle so that the mounting slides up the slots in the frame.

    Editar

  5. ULCO ntegrus PSV ventilator Battery Replacement: passo 5, imagem 1 %32

    • Pull the ventilator housing towards you so that the mounting tabs come out of the frame slots rest the ventilator housing on the plastic skirt at the rear of the workstation as shown in the photo.

    Editar

  6. ULCO ntegrus PSV ventilator Battery Replacement, Battery: passo 6, imagem 1 %32

    • Remove the main cover plate from the ventilator enclosure by removing all screws.

    Editar

    • Disconnect the battery.

    Editar

  8. ULCO ntegrus PSV ventilator Battery Replacement: passo 8, imagem 1 %32

    • Remove the four pan head screws (SM0308P) holding down the battery plate (EV9109) and battery (EV9108) and remove the battery plate and battery.

    Editar

  9. ULCO ntegrus PSV ventilator Battery Replacement: passo 9, imagem 1 %32

    • Install the new battery in the same location and screw down the battery plate onto the battery plate spacers so that the battery is firmly held in place.

    Editar

    • Reconnect the battery.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

com 2 outros contribuidores

Preston Myers

Membro desde: 04/09/20

493 Reputação

Autoria de 4 guias

Emblemas: 6

+3 outros emblemas

Equipe

Cal Poly, Team S7-G13, Paton Spring 2020 Membro de Cal Poly, Team S7-G13, Paton Spring 2020

CPSU-PATON-S20S7G13

Membros da 3

Autoria de 8 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 36