Introdução

Standard Keyboard with 10-key and touchpad with multi-touch control

  1. Turn the laptop off and remove all sources of power.
    • Turn the laptop off and remove all sources of power.

    • Flip the laptop over so that way the bottom is facing towards you.

    • Remove the two 6.6mm Phillips #0 screws from the battery.

    Adicionar comentário

  2. Pull the battery out of the laptop.
    • Pull the battery out of the laptop.

    Adicionar comentário

    • Remove the thirteen 6.6mm Phillips #0 screws on the back of the device.

    Adicionar comentário

    • Use a plastic opening tool to lift and remove the bottom panel.

    Adicionar comentário

    • Remove the six 2.3mm Phillips #0 screws from the motherboard.

    • Use a pair of tweezers to lift up the tab on the ZIF connector and pull out the ribbon cable.

    Adicionar comentário

    • Disconnect the wires from the motherboard.

    • Lift and remove the disk drive.

    • Lift and remove the hard drive.

    Adicionar comentário

    • Lift up the motherboard

    • Use tweezers to carefully peel apart IDE ribbon cables connected from motherboard to keyboard

    Adicionar comentário

    • Use a plastic opening tool to unlatch the keyboard from the device

    • Lift the keyboard off the laptop, careful of the IDE ribbon cable

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Pablo Andrade

Member since: 14-02-2018

939 reputação

7 Guides authored

Equipe

USF Tampa, Team S3-G1, Nance Spring 2018 Membro de USF Tampa, Team S3-G1, Nance Spring 2018

USFT-NANCE-S18S3G1

4 Membros

8 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 10

Últimos 30 dias: 43

Todo: 255