Introdução

This guide will go through the steps needed to install a new LCD panel.

Turn the computer over onto its back.
  • Turn the computer over onto its back.

Adicionar comentário

Slide the lock on the left side to the unlock position. Slide the lock on the right side to the unlock position until there is a clicking sound.
  • Slide the lock on the left side to the unlock position.

  • Slide the lock on the right side to the unlock position until there is a clicking sound.

Adicionar comentário

Remove the battery by sliding it out while both locks remain in the unlock position. Remove the battery by sliding it out while both locks remain in the unlock position.
  • Remove the battery by sliding it out while both locks remain in the unlock position.

Adicionar comentário

Use a plastic opening tool to unsnap the right hand side speaker cover. Use a plastic opening tool to unsnap the right hand side speaker cover.
  • Use a plastic opening tool to unsnap the right hand side speaker cover.

Adicionar comentário

Remove the rest of the cover by sliding it to the right and lifting the edge. Remove the rest of the cover by sliding it to the right and lifting the edge.
  • Remove the rest of the cover by sliding it to the right and lifting the edge.

Adicionar comentário

Remove all 8 plastic circular covers on the plastic screen bezel. Only 7 of these plastic covers will contain screws underneath.
  • Remove all 8 plastic circular covers on the plastic screen bezel.

  • Only 7 of these plastic covers will contain screws underneath.

  • Unscrew all screws with a Phillips head #00 screwdriver.

  • Seven 3.5 mm fine thread screws.

Adicionar comentário

Use a plastic opening tool to separate the screen bezel from the rest of the case. Pull at the top edge of the LCD to separate it from the top part of the case.
  • Use a plastic opening tool to separate the screen bezel from the rest of the case.

  • Pull at the top edge of the LCD to separate it from the top part of the case.

  • Separate the casing and the LCD only by an inch, since there are still wires connecting them.

Adicionar comentário

Use a Phillips #000 to unscrew the wire connected to the right face of the LCD. One 2.8 mm fine thread screw.
  • Use a Phillips #000 to unscrew the wire connected to the right face of the LCD.

  • One 2.8 mm fine thread screw.

Adicionar comentário

Flip the LCD over onto the back.
  • Flip the LCD over onto the back.

  • Gently pull the connection on the corner of the LCD to disconnect.

Adicionar comentário

Remove tape connecting lcd to the inverter. Use tweezers to remove lcd cable from the inverter.
  • Remove tape connecting lcd to the inverter.

  • Use tweezers to remove lcd cable from the inverter.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Alison Wendt

Member since: 18-04-2013

78 reputação

6 Guides authored

Equipe

Cal Poly, Team 21-51, Johann Spring 2013 Membro de Cal Poly, Team 21-51, Johann Spring 2013

CPSU-JOHANN-S13S21G51

3 Membros

6 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 4

Todo: 633