Peças

Não são necessárias peças.

Power down the TiVo and detach the power cable from the rear of the unit.
  • Power down the TiVo and detach the power cable from the rear of the unit.

    • Wait 5 minutes for the unit to fully discharge before proceeding to the next step.

Adicionar comentário

Remove the five T10 screws from the rear of the case using the Torx screwdriver.
  • Remove the five T10 screws from the rear of the case using the Torx screwdriver.

Adicionar comentário

  • Lift up and pull back the outer casing towards the rear of the unit.

I have the TiVo Series 2 model TCD746500 and the procedure for replacing a fan on my model is almost identical to the procedure described here, with one significant difference at this step: first pull/slide the outer casing back towards yourself and only thereafter pull it up.

Oscar Abraham Jaeger - Responder

  • Disconnect the power to the hard drive.

Adicionar comentário

  • Grab the hard drive data cable from both sides of the connector and unplug it from the hard drive.

    • Use extreme caution when unplugging connector and do not disconnect the data cable by pulling on the cable itself.

Adicionar comentário

  • Unscrew the two screws on the case of the hard drive with a T10 screwdriver.

  • Pull the hard drive up and out of the TiVo unit.

Adicionar comentário

  • Unscrew the four screws, shown in the picture, with a T-10 screwdriver.

  • Remove the hard drive from the case.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

Svyatoslav Markeyev

Member since: 16-04-2010

135 reputação

5 Guides authored

Equipe

Cal Poly, Team 33-79, Johann Spring 2010 Membro de Cal Poly, Team 33-79, Johann Spring 2010

CPSU-JOHANN-S10S33G79

4 Membros

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 1

Últimos 30 dias: 10

Todo: 6,713