Introdução

In case your remote just won't work and you have already tried replacing the batteries, this guide will walk you through removing the front cover and replacing the remote sensor on the inside of the cover.

Peças

Não são necessárias peças.

Unscrew the five 0.31 inch T-9 screws on the back cover.
  • Unscrew the five 0.31 inch T-9 screws on the back cover.

Adicionar comentário

Slide the cover towards the back until it is no longer under the front cover.
  • Slide the cover towards the back until it is no longer under the front cover.

Adicionar comentário

Lift the cover up and off the device.
  • Lift the cover up and off the device.

Adicionar comentário

Unplug the ribbon cable from the motherboard. Some force may be required for this step, so be careful not to rip the ribbon cable.
  • Unplug the ribbon cable from the motherboard. Some force may be required for this step, so be careful not to rip the ribbon cable.

Adicionar comentário

Unscrew the two 0.31 inch T-9 screws on the inside of the front cover.
  • Unscrew the two 0.31 inch T-9 screws on the inside of the front cover.

Adicionar comentário

Use a spudger to push the three tabs on the inside of the front cover up and forward to release the cover. Use a spudger to push the three tabs on the inside of the front cover up and forward to release the cover. Use a spudger to push the three tabs on the inside of the front cover up and forward to release the cover.
  • Use a spudger to push the three tabs on the inside of the front cover up and forward to release the cover.

Adicionar comentário

Pull the front cover down and away from the device to separate it completely. Be careful not to tear the ribbon cable as you are removing the front cover.
  • Pull the front cover down and away from the device to separate it completely. Be careful not to tear the ribbon cable as you are removing the front cover.

Adicionar comentário

Unscrew the two 0.31 inch T-9 screws on the back of the sensor.
  • Unscrew the two 0.31 inch T-9 screws on the back of the sensor.

Adicionar comentário

Lift the sensor up to remove it.
  • Lift the sensor up to remove it.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Shauna

Member since: 10-10-2011

37 reputação

2 Guides authored

Equipe

Cal Poly, Team 5-33, Amido Fall 2011 Membro de Cal Poly, Team 5-33, Amido Fall 2011

CPSU-AMIDO-F11S5G33

4 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Todo: 892