TDK Life on Record A33 Speaker Replacement

Introdução

The middle speaker can be taken apart and replaced if needed. A thin tool is required to take off the speaker guard as well as a Phillip's head screwdriver and a soldering iron to remove the speaker. Be careful when soldering the wires in the speaker.

O que você precisa

Passo 1 Speaker Guard

TDK Life on Record A33 Speaker Replacement, Speaker Guard: passo 1, imagem 1 %32

Push the nylon or metal spudger in the corner of the speaker guard.

Editar

Passo 2

Slowly lift the speaker up enough so that you can slide around the speaker guard.

Editar

Passo 3

Slide the nylon or metal spudger all around the speaker guard.

Editar

Passo 4

Remove the speaker guard. You can now replace the speaker guard on your TDK Life on Record A33.

Editar

Passo 5 Speaker

TDK Life on Record A33 Speaker Replacement, Speaker: passo 5, imagem 1 %32

TDK Life on Record A33 Speaker Replacement, Speaker: passo 5, imagem 2 %32

Remove all (4) 3mm screws in the middle speaker using a Phillip's head screwdriver.
You can also remove the speakers on the left and right.

Editar

Passo 6

Do not rip the wires inside the speaker when trying to open the middle speaker on the device.
Create an opening in the speaker by holding the device up and carefully grabbing the side of the speaker that pops out.

Editar

Passo 7

Wear safety goggles and have something to absorb the smoke from the soldering iron just in case.
Do not burn the wires of the speaker.
Remove the solder that connects the wires to the speaker. You should be able to now remove the speaker and replace it.