Sony Vaio VGN-SR140E Hard Drive Replacement

Introdução

The battery will need to be removed before servicing or replacing anything else on the device. The hard drive can be taken out after removing two screws. Be careful when removing the hard drive as it is attached to the motherboard by a thin ribbon cable.

O que você precisa

Passo 1 Battery

Sony Vaio VGN-SR140E Hard Drive Replacement, Battery: passo 1, imagem 1 %32

Turn the laptop over and orient it as shown in the figure.

Editar

Passo 2

Slide the lock latch to the right to release the battery lock.
Slide and hold the release latch to the left.

Editar

Passo 3

Use a fingernail or plastic opening tool lift the battery while holding the release latch.Rotate the battery up and away from you to remove it from the laptop.

Editar

Passo 4 Hard Drive

Sony Vaio VGN-SR140E Hard Drive Replacement, Hard Drive: passo 4, imagem 1 %32

Using a Phillips #1 screw driver, loosen both screws holding the cover in place. These screws are secured to the cover with retaining clips.

Editar

Passo 5

Lift the cover with a fingernail or plastic opening tool from the side where the screws are present and lift it off to the left.

Editar

Passo 6

The hard drive is covered by a thin, black, plastic flap. Gently lift the hard drive up and to the right.
Be careful not to damage the ribbon cable during this step.

Editar

Passo 7

Use the spudger or a fingernail to carefully release the lock securing the ribbon cable to the motherboard.

Editar

Passo 8

Grasp the ribbon cable carefully near the connector end. Remove it by pulling the cable away from the connector on the motherboard at a slightly upward angle.

Editar