Peças

Não são necessárias peças.

Flip the computer so that the bottom is facing up.
  • Flip the computer so that the bottom is facing up.

  • Look to the long edge where the computer screen is hinged and find the "release slide". It is located at the top left corner of the square indent.

Adicionar comentário

Use your finger to slide the release to the left.
  • Use your finger to slide the release to the left.

Adicionar comentário

  • While holding the release slide with one hand, use your opposite hand to pull the battery from its slot by gently shaking the battery left and right to help slide it out.

Adicionar comentário

  • Take out the screw in the center of the computer.

Adicionar comentário

  • Flip the computer right side up.

  • Open screen so that keyboard is visible.

Adicionar comentário

  • Use a plastic opening tool to gently lift the keyboard at a corner.

  • Make sure you get below the keyboard itself and not just the keys.

  • Slide the tool around the perimeter of the keyboard and it will start to lift.

Adicionar comentário

  • Do not pull the keyboard away from the computer. There is a ribbon cord attaching the keyboard to the computer.

  • Once the keyboard has been lifted at a few edges, lift the keyboard with both hands.

Adicionar comentário

  • Locate the ribbon cord behind the keyboard.

  • Locate a brown clamp attaching the keyboard to the computer.

  • Use a plastic opening tool to lift the clamp and release the cable.

  • Now the keyboard can be pulled away entirely.

Adicionar comentário

  • Take out the screw under the keyboard.

Adicionar comentário

  • Flip computer over and remove the 6 screws.

Adicionar comentário

  • Flip computer over again and unclip the plastic cover.

  • Do not be afraid to be rough, since the cover is hard to remove.

  • Be sure to remove the case slowly and unclip any ribbon cords that are attached.

Adicionar comentário

  • Locate the hard drive disk. The hard drive disk will be covered by a shiny lid.

  • Unscrew the lid with a #00 Phillips Head Screwdriver.

  • There are 3 screws holding it in.

  • Grab the lid by one corner and pull off the lid.

Adicionar comentário

  • Find the brown clip attached to the hard disk drive on the side facing the optical disk drive.

  • Carefully pull out the brown clip with your fingers.

Adicionar comentário

  • Hold the hard disk drive on the side where the brown clip was attached and lift it upwards to pull it out.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

6 outras pessoas concluíram este guia.

Jenny Wang

Member since: 03-04-2012

107 reputação

Autoria de 1 guia

Equipe

Cal Poly, Team 5-3, Forte Spring 2012 Membro de Cal Poly, Team 5-3, Forte Spring 2012

CPSU-FORTE-S12S5G3

5 Membros

6 Guides authored

Muito bom, me ajudou muito...

lordsan32 - Responder

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 2

Últimos 7 dias: 13

Últimos 30 dias: 49

Todo: 13,933