Este guia tem alterações mais recentes. Mudar para a última versão não verificada.
Introdução
The motherboard is the brain of your microcassette-corder. Following the steps in this guide will allow you to remove the motherboard and install a new one, saving your microcassette-corder.
O que você precisa
-
-
Find the arrow on the battery cover on the back of the device.
-
While pressing down on the arrow, slide the cover towards the bottom of the recorder until it clicks.
-
-
-
Remove the battery cover by first tilting it so it is at a right angle with the rest of the device.
-
Next, twist it to the side as shown in the second picture. The lid should simply snap off.
-
-
-
Use a spudger to push in the two tabs located on the bottom of the device.
-
It works best to push the tabs at an upward angle (towards the top of the battery compartment)
-
It may take a decent amount of force in order to push in the tabs.
I didn’t push on the tabs, but put a spudger along the seem and the clips released with minimal force!
-
-
-
-
Using tweezers, pull upward on the black tape which secures the wires.
-
Removing this tape allows you to move the wires out of the way for the next step.
-
-
-
If the replacement motherboard does not have the wire battery terminals attached, desolder the two battery connections on the motherboard.
-
Leave the wire battery terminals in place.
-
If the replacement motherboard has battery terminals attached, the connections do not need to be desoldered.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancelar: não concluí este guia.
Uma outra pessoa concluiu este guia.
Um comentário
Buenas tardes,podrían colaborar me con las referencias de las resistencias de control de 2.4 y 1.2 del motor o guiarme donde puedo adquirir esta información. bendiciones mil gracias. Antonio