Introdução

The Logic Board is the part that the keys hit and translates the signals to the phone.

Peças

Não são necessárias peças.

Remove the back cover and the battery. Remove the back cover and the battery. Remove the back cover and the battery.
  • Remove the back cover and the battery.

Adicionar comentário

Remove the 4 screws using a T6 precision screwdriver.
  • Remove the 4 screws using a T6 precision screwdriver.

  • Flip open the phone, and keep the back cover facing you.

Adicionar comentário

Take the plastic opening tool and run it between the phone case and phone body to loosen the key pad while the phone is open. Note: There are 2 clamps that lock it to the phone case (1 on each side).
  • Take the plastic opening tool and run it between the phone case and phone body to loosen the key pad while the phone is open.

  • Note: There are 2 clamps that lock it to the phone case (1 on each side).

Adicionar comentário

Flip the phone over and lift straight up on the key pad to remove it.
  • Flip the phone over and lift straight up on the key pad to remove it.

  • Be sure to hold the phone flat (parallel to the table), because there are loose parts that may fall out.

Adicionar comentário

Use the i Pod opening tool to remove the 2 ribbon wires (boxed in the photo) from the logic board.
  • Use the i Pod opening tool to remove the 2 ribbon wires (boxed in the photo) from the logic board.

Adicionar comentário

Gently lift the back of the logic board and then pull outwards. Be careful not to rip the ribbon wire.
  • Gently lift the back of the logic board and then pull outwards. Be careful not to rip the ribbon wire.

Adicionar comentário

If the parts are loose you can remove the black sim card reader and green vibrator before continuing, otherwise they may fall out. If the parts are loose you can remove the black sim card reader and green vibrator before continuing, otherwise they may fall out.
  • If the parts are loose you can remove the black sim card reader and green vibrator before continuing, otherwise they may fall out.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Tim

Member since: 20-04-2010

9 reputação

4 Guides authored

Equipe

Cal Poly, Team 7-12, Maness Spring 2010 Membro de Cal Poly, Team 7-12, Maness Spring 2010

CPSU-MANESS-S10S7G12

4 Membros

10 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Todo: 1,545