Ir para o conteúdo principal

Sony Ericsson W810I Camera Lens Replacement

Guia arquivado
Este guia é mantido exclusivamente para fins históricos. Use a versão atualizada do guia para executar o reparo.

O que você precisa

  1. Sony Ericsson W810I Camera Lens Replacement, Camera Lens: passo 1, imagem 1 %32
    • Ensure the phone is switched off. Then press down firmly against the Cingular icon with your thumb.

    • Slide the panel down and remove the latch

  2. Sony Ericsson W810I Camera Lens Replacement: passo 2, imagem 1 %32 Sony Ericsson W810I Camera Lens Replacement: passo 2, imagem 2 %32
    • Lift the battery with your fingers and pull it out of the casing.

    • Remove the SIM card as well if you have one

  3. Sony Ericsson W810I Camera Lens Replacement: passo 3, imagem 1 %32
    • Remove the two outer screws using a T7 Torx screwdriver.

  4. Sony Ericsson W810I Camera Lens Replacement: passo 4, imagem 1 %32
    • Remove the two smaller inner screws with the Mini-Phillips screwdriver.

  5. Sony Ericsson W810I Camera Lens Replacement: passo 5, imagem 1 %32 Sony Ericsson W810I Camera Lens Replacement: passo 5, imagem 2 %32
    • Remove the back faceplate on the camera side with the blue hand wedge.

  6. Sony Ericsson W810I Camera Lens Replacement: passo 6, imagem 1 %32 Sony Ericsson W810I Camera Lens Replacement: passo 6, imagem 2 %32 Sony Ericsson W810I Camera Lens Replacement: passo 6, imagem 3 %32
    • Flip the phone over and pry off the front faceplate using multiple blue hand-wedges.

    • Separate the keypad from the logic board by turning it upside down and allowing it to fall into your hand.

  7. Sony Ericsson W810I Camera Lens Replacement: passo 7, imagem 1 %32
    • Remove the two remaining screws at the top corners of the phone.

  8. Sony Ericsson W810I Camera Lens Replacement: passo 8, imagem 1 %32
    • Remove the logic board with multiple blue hand-wedges. Prise the logic board away carefully to avoid damaging it or snapping the wiring.

  9. Sony Ericsson W810I Camera Lens Replacement: passo 9, imagem 1 %32
    • From the inside of the panel, press down on the camera lens to pop it out of its mounting.

    • Replace the lens and reverse the process to reassemble the device.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Ben Micucci

Membro desde: 10/14/11

186 Reputação

Autoria de 5 guias

Equipe

James Madison, Team 2-2, Allen Fall 2011 Membro de James Madison, Team 2-2, Allen Fall 2011

JMU-ALLEN-F11S2G2

Membros da 2

Autoria de 10 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 5

Últimos 30 dias: 5

Duração total: 1,407