Peças

Não são necessárias peças.

Lie phone screen down on a flat smooth surface so that the camera, logos, and speaker face up.
  • Lie phone screen down on a flat smooth surface so that the camera, logos, and speaker face up.

  • Using the provided notch on the bottom of the back cover, insert a plastic opening tool and lift upwards to remove the back cover of the phone.

Adicionar comentário

Lie the cover beside the phone upon removal.  Your assembly should appear as shown this far.
  • Lie the cover beside the phone upon removal. Your assembly should appear as shown this far.

  • Insert the plastic opening tool into the crevice between the camera and the battery of the phone. Using a gentle prying motion, lift the end of the battery and remove.

  • After removal, recycle the defective battery appropriately. Take the replacement battery and lie it near the phone as shown. Your assembly should resemble the presented picture. Note that the cover is not included in this particular photo.

Adicionar comentário

  • Flip the phone over and remove the Sony Ericsson sticker that is over the phone's ear speaker.

  • Using a T5 screwdriver, loosen and remove the two screws under the Sony Ericsson sticker by turning them counterclockwise.

Adicionar comentário

  • Using a mini phillips head screwdriver, loosen and remove these screws by turning them counterclockwise.

  • Be careful to remember and organize screws to their unique positions in this step as well as future steps.

Adicionar comentário

  • Insert a prybar in bottom crack between the front and back plates (see picture) and use a gentle upward pull to separate the back case from the front case.

  • Side buttons/controls may fall from their place in between the back and front casings.

Adicionar comentário

  • Using a T5 screwdriver, loosen and remove the two screws by turning them counterclockwise.

Adicionar comentário

  • Using a prybar and a gentle outward motion, separate the front plate from the inner phone workings.

  • After removing the back plate and the front plate, the phone should look like the remaining pictures.

Adicionar comentário

  • Using a mini phillips head screwdriver, loosen and remove the screw located on the front number pad by turning it counterclockwise.

  • After removing this screw, the speaker will be free to move and the phone will look like this remaining picture.

  • To reassemble the phone, follow these steps in reverse order.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Ldellos

Member since: 12-03-2012

109 reputação

6 Guides authored

Equipe

Clemson, Team 1-4, Benson Spring 2012 Membro de Clemson, Team 1-4, Benson Spring 2012

CLEM-BENSON-S12S1G4

4 Membros

14 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Todo: 882