Peças

Não são necessárias peças.

Remove 2 screws from thumb dial panel on the back of the device.
  • Remove 2 screws from thumb dial panel on the back of the device.

Adicionar comentário

Remove 1 screw from upper right corner on the back of the device.
  • Remove 1 screw from upper right corner on the back of the device.

Adicionar comentário

  • Remove 1 screw from thumb dial panel on the right side of the device.

Adicionar comentário

  • Remove screw from lower right side of the device.

Adicionar comentário

  • Remove 1 screw from the lower left side of the device.

Adicionar comentário

  • Remove 2 screws from the bottom of the device.

Adicionar comentário

  • Remove the thumb dial panel by sliding it away from the device.

Adicionar comentário

  • Remove the back panel exposing the inside of the device.

Adicionar comentário

  • Locate thumb dial on top right side of the board.

Adicionar comentário

  • Follow ribbon wire to locate where it plugs into the board. The plug is a flat black square.

Adicionar comentário

  • Pull plug straight up to remove from board.

Adicionar comentário

  • Place plug back on board and push down on center to secure to board.

Adicionar comentário

  • Make sure new thumb dial is sitting flat and the screw holes line up with holes in the board.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Rob

Member since: 04-10-2011

1 reputação

2 Guides authored

Equipe

UW Stout, Team 5-6, Zhou Fall 2011 Membro de UW Stout, Team 5-6, Zhou Fall 2011

UWSTOUT-ZHOU-F11S5G6

4 Membros

2 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Todo: 873