Peças

Não são necessárias peças.

Remove two screws from the thumb dial panel on the back of the device
  • Remove two screws from the thumb dial panel on the back of the device

Adicionar comentário

Remove 1 screw from upper right corner on the back of the device.
  • Remove 1 screw from upper right corner on the back of the device.

Adicionar comentário

Romove 1 screw from thumb dial panel on the righ side of the device.
  • Romove 1 screw from thumb dial panel on the righ side of the device.

Adicionar comentário

Remove screw from lower right side of the device.
  • Remove screw from lower right side of the device.

Adicionar comentário

Remove 1 screw from the lower left side of the device.
  • Remove 1 screw from the lower left side of the device.

Adicionar comentário

Romove 2 screws from the bottom of the device.
  • Romove 2 screws from the bottom of the device.

Adicionar comentário

Remove the thumb dial panel by sliding it away from the device.  (note: you can do this step earlier after you remove all screws from thumb drive panel)
  • Remove the thumb dial panel by sliding it away from the device. (note: you can do this step earlier after you remove all screws from thumb drive panel)

Adicionar comentário

Remove the back panel exposing the inside of the device.
  • Remove the back panel exposing the inside of the device.

Adicionar comentário

Remove 1 screw located on board below battery.
  • Remove 1 screw located on board below battery.

Adicionar comentário

Unplug male battery plug on the battery wire from the female battery plug on the board.
  • Unplug male battery plug on the battery wire from the female battery plug on the board.

Adicionar comentário

remove the battery from the device by sliding it out of the side of the device
  • remove the battery from the device by sliding it out of the side of the device

Adicionar comentário

slide new battery under the board from the side of the device.
  • slide new battery under the board from the side of the device.

Adicionar comentário

Plug battery back into board.
  • Plug battery back into board.

Adicionar comentário

Place screw back into board.
  • Place screw back into board.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Rob

Member since: 04-10-2011

1 reputação

2 Guides authored

Equipe

UW Stout, Team 5-6, Zhou Fall 2011 Membro de UW Stout, Team 5-6, Zhou Fall 2011

UWSTOUT-ZHOU-F11S5G6

4 Membros

2 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 7

Todo: 1,436