Conserte seus objetos Comunidade Loja

Skytex SP728 Battery Replacement

Introdução

This repair guide will walk you through the primary steps of replacing the battery in the Skytex Skypad SP728.

O que você precisa

  1. Skytex SP728 Battery Replacement, Case: passo 1, imagem 1 %32

    • Make sure the device is powered off

    • Rotate the device so the ports and screws face you

    Editar

  2. Skytex SP728 Battery Replacement: passo 2, imagem 1 %32

    • Using a small phillips screwdriver, unscrew both end screws

    Editar

  3. Skytex SP728 Battery Replacement: passo 3, imagem 1 %32

    • Using a plastic opening tool, work your way around the edge of the device, separating the case from the rest of the device

    Editar

  5. Skytex SP728 Battery Replacement: passo 4, imagem 1 %32

    • Once the case has been loosened, pry the backing off gently with your hands.

    • Make sure to remove the case gently as extra force can break the clasps or the case itself.

    Editar

  6. Skytex SP728 Battery Replacement, Battery: passo 5, imagem 1 %32

    • Remove the yellow and black tape around the battery very carefully

    Editar

  7. Skytex SP728 Battery Replacement: passo 6, imagem 1 %32 Skytex SP728 Battery Replacement: passo 6, imagem 2 %32

    • Use the soldering iron and remove soldered connections to separate the wires connected to the battery from the circuit board.

    • Follow the link below for additional soldering information Como soldar e dessoldar contatos

    • Soldering uses heat so make sure you are careful while doing it. Also, excessive heat can damage the components. So do not apply the soldering iron on a component for extended periods of time.

    Editar

  8. Skytex SP728 Battery Replacement: passo 7, imagem 1 %32

    • Using the plastic opening tool, lift up the battery from right edge and set aside.

    • Make sure that you take the battery out very carefully without bending it or damaging it as it contains toxic chemicals.

    • While soldering the wires for the new battery, remember that the red wire has to be connected to the positive terminal and the black wire has to be connected to the negative terminal.

    Editar
Conclusão

To reassemble your device with a new battery, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Autor(a)

com 4 outros contribuidores

Galika Adhikari

Membro desde: 01/21/15

248 Reputação

Autoria de 2 guias

Emblemas: 6

+3 outros emblemas

Equipe

USF Tampa, Team 5-1, Brown Winter 2015 Membro de USF Tampa, Team 5-1, Brown Winter 2015

USFT-BROWN-W15S5G1

Membros da 4

Autoria de 11 guias

Um comentário

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 2

Duração total: 732