Introdução

The motherboard going bad can cause numerous problems for the device such as the the buttons not functions, the screen not working, and even cause the whole device to be defective.

Peças

Não são necessárias peças.

  1. Wedge a plastic opening tool in between the case.
    • Wedge a plastic opening tool in between the case.

  2. Starting with the bottom left corner, press down on the plastic opening tool to unhook the latches on the inside of the device. You have to start with the bottom left and right corners, and then flip the device to over and do the top of the device. You have to start with the bottom left and right corners, and then flip the device to over and do the top of the device.
    • Starting with the bottom left corner, press down on the plastic opening tool to unhook the latches on the inside of the device.

    • You have to start with the bottom left and right corners, and then flip the device to over and do the top of the device.

  3. Once unclipped, separate the back casing from the device.
    • Once unclipped, separate the back casing from the device.

  4. Free shipping on all orders over US$100,00 or containing a Pro Tech Toolkit!

    Visite Nossa Loja
  5. Remove the three 5.4mm JIS #00 screws from the motherboard. Remove the three 5.4mm JIS #00 screws from the motherboard.
    • Remove the three 5.4mm JIS #00 screws from the motherboard.

  6. Unlatch the two clips located at the top of the device that hold the motherboard in place.
    • Unlatch the two clips located at the top of the device that hold the motherboard in place.

  7. Lift the motherboard up from the bottom.
    • Lift the motherboard up from the bottom.

  8. Lift the screen up, so you can see where it is attached to the motherboard.
    • Lift the screen up, so you can see where it is attached to the motherboard.

  9. Use a spudger to flip up the retaining flap on the display ribbon cable ZIF socket.
    • Use a spudger to flip up the retaining flap on the display ribbon cable ZIF socket.

  10. Carefully pull the ribbon out from the ZIF connector.
    • Carefully pull the ribbon out from the ZIF connector.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Angel Rivera

Member since: 25-01-2018

505 reputação

5 Guides authored

Equipe

USF Tampa, Team S7-G2, Passmore Spring 2018 Membro de USF Tampa, Team S7-G2, Passmore Spring 2018

USFT-PASSMORE-S18S7G2

4 Membros

5 Guides authored

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 4

Últimos 30 dias: 34

Todo: 231