Peças

Não são necessárias peças.

  1. Place the TV face down on a flat smooth surface as to not scratch the screen.
    • Place the TV face down on a flat smooth surface as to not scratch the screen.

    • Remove the four 8mm screws attaching the stand to the TV.

    Adicionar comentário

  2. Lift the stand off the television.
    • Lift the stand off the television.

    Adicionar comentário

    • Remove the two back panels to display the audio and video inputs..

    Adicionar comentário

    • Remove the eight 6mm Phillips screws around the edge.

    • Remove the two 6mm Phillips near the inputs.

    Adicionar comentário

    • Lift and remove the back case of the television.

    Adicionar comentário

    • Remove the two speaker cables and the connector from the circuit board by pinching the plastic connectors and firmly pulling up.

    • Pull on the plastic part of the connector, even though it may seem easiest to pull on the wires.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the green and gray power connector from the side of the buttons panel at the top of the television.

    • Remove the green/gray to orange/gray connector from the center of the circuit board.

    Adicionar comentário

    • Remove the four 5mm phillips screws attaching the LCD and circuit board to the front case.

    Adicionar comentário

    • Lift the circuit board/LCD block from the case by lifting the near side of the circuit board and sliding it under the button frame.

    Adicionar comentário

    • Flip the LCD/circuit board so that the circuit board faces up.

    Adicionar comentário

    • Remove the three 5mm Philips screws attaching the circuit board to the LCD.

    • Remove the five 6mm Phillips screws from the edges of the circuit board attacking it to the LCD.

    Adicionar comentário

    • Turn the circuit board so the blue and pink side cables are facing you.

    • Hold the white plastic, squeeze and pull from the sides.

    • Pull on the plastic part of the connector, even though it may seem easiest to pull on the wires.

    Adicionar comentário

    • Turn the television so the right hand side is facing you.

    • To remove the ribbon cables, fold the brown casing down and pull directly upward on the ribbon.

    • Turn the television so the left hand side is facing you, and remove the ribbon cable in the same manner.

    Adicionar comentário

    • Turn the circuit board so that the left side is facing you.

    • Detach the data cable from the circuit board.

    • To do this, slide your finger nail from the middle of the connector until the little black tabs rotates down toward the board as shown in the second picture.

    Adicionar comentário

    • Lift and remove the circuit board from the LCD frame.

    Adicionar comentário

    • Now you have your LCD.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

Robert Hobson

Member since: 20-01-2011

1.275 reputação

9 Guides authored

Equipe

Cal Poly, Team 1-11, Amido Winter 2011 Membro de Cal Poly, Team 1-11, Amido Winter 2011

CPSU-AMIDO-W11S1G11

4 Membros

9 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 14

Últimos 30 dias: 39

Todo: 6,905