Conserte seus objetos Comunidade Loja

Shark Ultimate Professional Reservoir Replacement

O que você precisa

  1. Shark Ultimate Professional Reservoir Replacement, Reservoir: passo 1, imagem 1 %32 Shark Ultimate Professional Reservoir Replacement, Reservoir: passo 1, imagem 2 %32 Shark Ultimate Professional Reservoir Replacement, Reservoir: passo 1, imagem 3 %32

    • Remove the two screws at the back of the iron.

    • Remove the back cover piece.

    • Make sure iron is unplugged and cooled off.

    Editar

  2. Shark Ultimate Professional Reservoir Replacement: passo 2, imagem 1 %32 Shark Ultimate Professional Reservoir Replacement: passo 2, imagem 2 %32

    • Remove the two screws holding the white clamp to the iron.

    • Remove the two screws holding the black wires to the body of the iron.

    • Removing the left black wire will also free the red wire, attached by the same screw.

    Editar

  4. Shark Ultimate Professional Reservoir Replacement: passo 3, imagem 1 %32

    • Pull the split end of the power cord upward through the ball joint of the iron.

    • Set aside power cord.

    Editar

  5. Shark Ultimate Professional Reservoir Replacement: passo 4, imagem 1 %32 Shark Ultimate Professional Reservoir Replacement: passo 4, imagem 2 %32 Shark Ultimate Professional Reservoir Replacement: passo 4, imagem 3 %32

    • Remove remaining screws that hold a wire on the bottom (brown and blue).

    • Unscrew from left to right.

    • Unclip the black adapter piece on the bottom right.

    • Wires order (from left to right): Brown, Blue, Red, Black

    Editar

  6. Shark Ultimate Professional Reservoir Replacement: passo 5, imagem 1 %32 Shark Ultimate Professional Reservoir Replacement: passo 5, imagem 2 %32

    • Remove two screws (left and right) affixed to circuit board.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

3 outras pessoas executaram este guia.

Autor(a)

com 1 outro contribuidor

Drew Carff

Membro desde: 10/23/17

868 Reputação

Autoria de 5 guias

Emblemas: 14

+11 outros emblemas

Equipe

USF Tampa, Team S1-G4, Leahy Fall 2017 Membro de USF Tampa, Team S1-G4, Leahy Fall 2017

USFT-LEAHY-F17S1G4

Membros da 3

Autoria de 10 guias

3 comentários

i am trying to replace the thermal cutoff but can’s remember the wire inside how to replace

primrose33166 - Responder

I have a constant leak in the vertical position - long after the iron is cold. The repair presented is well done. However it stopped short and doesn't get to the reservoir - thanks

Dalmacca-Hame - Responder

Then WHAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAT?

Muhammad Ahmad - Responder

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 2

Últimos 7 dias: 10

Últimos 30 dias: 27

Duração total: 2,146