Introdução

Instructions on how to replace a defective Sega Dreamcast power supply with a working power supply.

Peças

Não são necessárias peças.

Verify that the console is disconnected from the AC outlet before you begin. Flip the console over on its back.
  • Verify that the console is disconnected from the AC outlet before you begin.

  • Flip the console over on its back.

  • Take note of your model number, in case replacement parts are needed.

Adicionar comentário

Remove the expansion bay by applying pressure to the small clip on the expansion bay while prying it away from the console. Remove the expansion bay by applying pressure to the small clip on the expansion bay while prying it away from the console. Remove the expansion bay by applying pressure to the small clip on the expansion bay while prying it away from the console.
  • Remove the expansion bay by applying pressure to the small clip on the expansion bay while prying it away from the console.

Adicionar comentário

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Locate and remove all four black 12mm Phillips #02 screws from the underside of the console.
  • Locate and remove all four black 12mm Phillips #02 screws from the underside of the console.

  • Note: Remove the expansion bay to locate the fourth screw

Adicionar comentário

Internal components can be loose. Be careful that they do not fall out when removing the cover.
  • Internal components can be loose. Be careful that they do not fall out when removing the cover.

  • Turn the console right side up.

  • Remove the top cover by gently lifting the upper portion of the console.

Adicionar comentário

Unplug the device from the outlet. If you have just powered off the system, allow a few minutes for the capacitors to discharge before you begin working. Remove the white female pin head by pinching and lifting directly up on the harness.
  • Unplug the device from the outlet. If you have just powered off the system, allow a few minutes for the capacitors to discharge before you begin working.

  • Remove the white female pin head by pinching and lifting directly up on the harness.

  • Remove the two Philips #02 screws from the board.

  • Remove the power board. Using both hands, gently lift the power board away from the console without damaging the male pin head

Adicionar comentário

Remove the unit. Carefully remove the power board from the console by lightly grasping the board by the edge and lifting directly upward. Remove the two 10mm #02 Philips screws to detach the switch module from the console.
  • Remove the unit. Carefully remove the power board from the console by lightly grasping the board by the edge and lifting directly upward.

  • Remove the two 10mm #02 Philips screws to detach the switch module from the console.

  • Purchase a replacement power board.

Make sure you keep the small plastic divider (the little piece of transparent plastic film) in its place, or else your new power supply may find itself with a "grounding" sensation.

nuts32605 - Responder

Conclusão

To reassemble your device, follow these instructions in reverse order.

5 outras pessoas concluíram este guia.

Jacks216

Member since: 25-11-2009

87 reputação

Autoria de 1 guia

Equipe

Cal Poly, Team 5-1, Regan Fall 2009 Membro de Cal Poly, Team 5-1, Regan Fall 2009

CPSU-REGAN-F09S5G1

5 Membros

23 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 3

Últimos 7 dias: 15

Últimos 30 dias: 85

Todo: 12,354