Peças

Não são necessárias peças.

Using a Phillips head screwdriver remove  six screws from the bottom of the console. The six screws are marked.
  • Using a Phillips head screwdriver remove six screws from the bottom of the console.

    • The six screws are marked.

Adicionar comentário

Remove the two screws that attach the Genesis' connector to the rest of the console.
  • Remove the two screws that attach the Genesis' connector to the rest of the console.

    • The two screws are marked in the diagram.

Adicionar comentário

Slide the lock tab to the left to separate the halves of the console.
  • Slide the lock tab to the left to separate the halves of the console.

Adicionar comentário

Lift from the left side to remove the top of the case.
  • Lift from the left side to remove the top of the case.

Adicionar comentário

Using the spudger, pry the cover off of the Genesis attachment.
  • Using the spudger, pry the cover off of the Genesis attachment.

Adicionar comentário

Lift the top of the case to remove the cover.
  • Lift the top of the case to remove the cover.

Adicionar comentário

Remove the faceplate by pulling it up, then out.
  • Remove the faceplate by pulling it up, then out.

Adicionar comentário

Remove metal plate by unscrewing the three screws with the Phillips head screwdriver and then lifting the plate. The three screws are shown on the diagram.
  • Remove metal plate by unscrewing the three screws with the Phillips head screwdriver and then lifting the plate.

    • The three screws are shown on the diagram.

Adicionar comentário

Remove the two screws from the plastic bar. The two screws are shown pictured.
  • Remove the two screws from the plastic bar.

    • The two screws are shown pictured.

Adicionar comentário

To remove the CD tray Remove the four screws with the Phillips head screwdriver.
  • To remove the CD tray

    • Remove the four screws with the Phillips head screwdriver.

Adicionar comentário

Carefully unplug the wire connected to optical reader.
  • Carefully unplug the wire connected to optical reader.

Adicionar comentário

Remove the four screws on the underside of the CD tray with a small Phillips head screwdriver. The four screws are highlighted on the diagram.
  • Remove the four screws on the underside of the CD tray with a small Phillips head screwdriver.

    • The four screws are highlighted on the diagram.

  • The four springs below the circuit board are attached to the screws, so be careful not to lose them when you remove the screws.

Adicionar comentário

Carefully remove the CD tray from circuit board.
  • Carefully remove the CD tray from circuit board.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

sskyllin

Member since: 18-10-2010

21 reputação

2 Guides authored

Equipe

Cal Poly, Team 5-14, Maness Fall 2010 Membro de Cal Poly, Team 5-14, Maness Fall 2010

CPSU-MANESS-F10S5G14

5 Membros

6 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 24

Todo: 6,676