Peças

Não são necessárias peças.

Place the monitor face down.
  • Place the monitor face down.

  • Remove the four 11.5mm screws with a #2 Phillips screwdriver.

  • Remove the stand by pulling it out.

Adicionar comentário

Remove two 11.5mm screws with a  #2 Phillips screwdriver.
  • Remove two 11.5mm screws with a #2 Phillips screwdriver.

  • Remove the plastic bar.

Adicionar comentário

  • Using a #2 Phillips screwdriver, remove the six 7mm screws at the circled locations.

Adicionar comentário

  • Pry the monitor using the plastic opening tool to release the clips holding the cover on.

    • There are four clips on each side, four on the top, and one on the bottom.

    • You may hear a loud snapping noise when releasing the clips. Do not be alarmed, it is natural.

  • Once all the clips have been released, remove the cover by pulling it up.

Adicionar comentário

  • Using the #2 Phillips screwdriver, remove the one 6mm screw.

  • Unplug the indicated cable by pulling on the base.

  • Slide the cover toward the top of the monitor.

  • Remove the cover.

Adicionar comentário

  • Disconnect the two connectors to the speakers by gently pulling on the hard plastic straight up.

Adicionar comentário

  • Carefully peel the tape from the board.

Adicionar comentário

  • Flip the monitor so the screen is facing you.

  • Using Phillips #2 screwdriver remove the four 6.25 mm screws securing the speakers:

Adicionar comentário

  • Carefully lift the speakers up.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Xenia Leon Rodriguez

Member since: 26-09-2012

37 reputação

Autoria de 1 guia

Equipe

Cal Poly, Team 16-56, Forte Fall 2012 Membro de Cal Poly, Team 16-56, Forte Fall 2012

CPSU-FORTE-F12S16G56

5 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Todo: 315