Peças

Não são necessárias peças.

  1. Place the monitor face down.
    • Place the monitor face down.

    • Remove the four 11.5mm screws with a #2 Phillips screwdriver.

    • Remove the stand by pulling it out.

    Adicionar comentário

  2. Remove two 11.5mm screws with a  #2 Phillips screwdriver.
    • Remove two 11.5mm screws with a #2 Phillips screwdriver.

    • Remove the plastic bar.

    Adicionar comentário

    • Using a #2 Phillips screwdriver, remove the six 7mm screws at the circled locations.

    Adicionar comentário

    • Pry the monitor using the plastic opening tool to release the clips holding the cover on.

      • There are four clips on each side, four on the top, and one on the bottom.

      • You may hear a loud snapping noise when releasing the clips. Do not be alarmed, it is natural.

    • Once all the clips have been released, remove the cover by pulling it up.

    Adicionar comentário

    • Using the #2 Phillips screwdriver, remove the one 6mm screw.

    • Unplug the indicated cable by pulling on the base.

    • Slide the cover toward the top of the monitor.

    • Remove the cover.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Ted Hsueh

Member since: 20-09-2012

170 reputação

3 Guides authored

Equipe

Cal Poly, Team 16-56, Forte Fall 2012 Membro de Cal Poly, Team 16-56, Forte Fall 2012

CPSU-FORTE-F12S16G56

5 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 2

Todo: 316