Peças

Não são necessárias peças.

On the back side of the unit, remove the three 8.1mm screws marked with a Phillips #1 screwdriver.
  • On the back side of the unit, remove the three 8.1mm screws marked with a Phillips #1 screwdriver.

Adicionar comentário

From the back, lift the case upwards away from the unit then forwards, releasing the prongs on the front. From the back, lift the case upwards away from the unit then forwards, releasing the prongs on the front.
  • From the back, lift the case upwards away from the unit then forwards, releasing the prongs on the front.

Adicionar comentário

There is one group of wires located towards the front of the case and attached directly to the motherboard and the case. Using two fingers in a pinching motion, release the wire from the clip and disconnect it. There is one group of wires located towards the front of the case and attached directly to the motherboard and the case. Using two fingers in a pinching motion, release the wire from the clip and disconnect it. There is one group of wires located towards the front of the case and attached directly to the motherboard and the case. Using two fingers in a pinching motion, release the wire from the clip and disconnect it.
  • There is one group of wires located towards the front of the case and attached directly to the motherboard and the case. Using two fingers in a pinching motion, release the wire from the clip and disconnect it.

Adicionar comentário

Remove the cover from the device.
  • Remove the cover from the device.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

3 outras pessoas concluíram este guia.

Breanna Ainsworth

Member since: 30-01-2018

258 reputação

Autoria de 1 guia

Equipe

Baylor, Team S2-G1, Johnson Spring 2018 Membro de Baylor, Team S2-G1, Johnson Spring 2018

BU-JOHNSON-S18S2G1

3 Membros

6 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 3

Todo: 69