Introdução

Step-by-step guide for removing/replacing keypad.

Peças

Não são necessárias peças.

  1. Locate the button on the bottom of the phone. Once located, press and hold the button down.
    • Locate the button on the bottom of the phone. Once located, press and hold the button down.

  2. While holding the button down, remove the back cover of the phone.
    • While holding the button down, remove the back cover of the phone.

    • Use the size 00 Phillips screwdriver to remove the four screws located on the back of the phone. These screws are circled in yellow in the given image.

    • Using the same 00 Phillips screwdriver, remove the two screws at the bottom back plate of the phone near the camera and the speaker.

    • These screws will be 7.25 mm long.

    • Before proceeding, locate the USB port (where the charger can be plugged in) and open it using the iFixit Opening Tool.

    • Failure to open USB port cover at this stage may result in damaging the device.

    • Remove the screws on either side of the camera/speaker with a Phillips 00 screwdriver.

    • These screws will be 5.45 mm long.

    • Use the iFixit Opening Tool to begin removing the camera/speaker from the logic board.

    • Practice caution to prevent damage to the attaching ribbon.

    • To completely remove the camera/speaker, locate the orange attachment beneath it (as shown in the image).

    • Then, use the iFixit Opening Tool to gently pry the camera/speaker off.

    • Use the iFixit Opening Tool to pop off the yellow tab on the logic board.

    • Use the iFixit Opening Tool to pop off the other orange tab to free the logic board.

    • To completely remove the logic board, use the iFixit Opening Tool to pop it up, then use your fingers to pull it out.

    • Do not be alarmed if the volume and hold switch buttons are removed from the logic board.

    • Open/swivel the phone so the back of the LCD panel is visible.

    • Use the iPod opening tool to pry the keypad from the hinge on the back of the device.

    • A moderate amount of force may need to be applied.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Renee Kuzniar

Member since: 13-04-2010

82 reputação

4 Guides authored

Equipe

Cal Poly, Team 6-18, Maness Spring 2010 Membro de Cal Poly, Team 6-18, Maness Spring 2010

CPSU-MANESS-S10S6G18

3 Membros

12 Guides authored

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 1

Todo: 1,649