Introdução

This guide will teach you how to pry open your screen through the front side of the phone.

Melt the adhesive on the screen by applying a blow dryer directly on the screen.
  • Melt the adhesive on the screen by applying a blow dryer directly on the screen.

  • Your phone is hot, please do not touch it with your bare hand.

Adicionar comentário

Wedge the metal spudger in between the screen and the frame to begin separating them.
  • Wedge the metal spudger in between the screen and the frame to begin separating them.

  • It would be easier to separate the screen from the sealing adhesive on the frame if you with more than one metal spudger.

  • Your phone might no longer be watertight after you reassemble it.

Adicionar comentário

  • Slide the metal spudger around the phone at least once.

  • It would be easier to slide your metal spudger if you apply the blow dryer to where you are currently sliding.

Adicionar comentário

  • Lift the screen up with your hands.

  • Please wash your hands thoroughly with hot water and soap after you finish.

Adicionar comentário

  • Use the tweezers to disconnect the screen from the phone by detaching the connection.

Adicionar comentário

  • Clean the rest of the adhesive left on the phone by scraping it off with a metal tool.

  • Apply rubbing alcohol on the adhesive to make sure phone is free of any adhesive. Do this by applying some rubbing alcohol onto a napkin.

  • Lightly proceed to clean the phone with that napkin.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Erick Vazquez

Member since: 18-04-2018

135 reputação

Autoria de 1 guia

Equipe

Cal Poly, Team S18-G1, Livingston Spring 2018 Membro de Cal Poly, Team S18-G1, Livingston Spring 2018

CPSU-LIVINGSTON-S18S18G1

4 Membros

14 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 22

Últimos 7 dias: 111

Últimos 30 dias: 487

Todo: 1,416