Pular para o conteúdo principal

Introdução

Step-by-step guild to replacing your old worn out keyboard buttons.

Peças

Nenhum componente especificado.

  1. Press button on back of phone below camera.
    • Press button on back of phone below camera.

    • While button is depressed, remove the back panel of the phone by sliding off (not shown in picture).

  2. Grasp the battery near the bottom with two fingers.
    • Grasp the battery near the bottom with two fingers.

    • Lift battery up and out gently.

  3. Using an iPod opening tool, remove the screw cover in the top left corner by lifting it up.
    • Using an iPod opening tool, remove the screw cover in the top left corner by lifting it up.

  4. Kit de Reparo de Bateria do MacBook

    A partir de $69.99

    Buy Now

    Kit de Reparo de Bateria do MacBook

    A partir de $69.99

    Buy Now
  5. Use the Phillips #00 screwdriver to remove the six screws on the back of the phone. Three are evenly spaced on each side.
    • Use the Phillips #00 screwdriver to remove the six screws on the back of the phone. Three are evenly spaced on each side.

    • The upper right screw is 4.5mm while the rest are 6.5mm.

  6. Slide the iPod opening tool into the seam on the side of the phone and turn it slightly to unhook the eight clips. There are three clips on each side and two at the bottom of the phone.
    • Slide the iPod opening tool into the seam on the side of the phone and turn it slightly to unhook the eight clips.

    • There are three clips on each side and two at the bottom of the phone.

  7. Once all eight of the clips have been unhooked, lift the back panel off of the phone.
    • Once all eight of the clips have been unhooked, lift the back panel off of the phone.

    • Be careful not to remove the front panel. It is still connected to the phone chassis by a ribbon cable located in the bottom right side of the motherboard.

  8. Using an iPod opening tool, unlatch the ribbon cable located in the lower right corner of the motherboard.
    • Using an iPod opening tool, unlatch the ribbon cable located in the lower right corner of the motherboard.

    • Carefully remove the ribbon.

  9. Remove the front faceplate.
    • Remove the front faceplate.

  10. Grasp the rubber keyboard in the corner with your fingers and lift to remove.
    • Grasp the rubber keyboard in the corner with your fingers and lift to remove.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Chris

Membro desde: 20-04-2011

23 reputação

Autoria de 1 guia

Equipe

Cal Poly, Team 15-15, Regan Spring 2011 Membro de Cal Poly, Team 15-15, Regan Spring 2011

CPSU-REGAN-S11S15G15

5 Membros

5 Guias de autoria

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Todo: 1,576