Conserte seus objetos Comunidade Loja

Ryobi RJ1861V Saw Bar Assembly Replacement

Introdução

This guide demonstrates how to remove and replace the saw bar assembly in a Ryobi RJ1861V reciprocating saw.

O que você precisa

  1. Ryobi RJ1861V Saw Bar Assembly Replacement, Saw Bar Assembly: passo 1, imagem 1 %32

    • Use a Torx T5 screwdriver to remove the single 8 mm screw securing the shoe.

    Editar

  2. Ryobi RJ1861V Saw Bar Assembly Replacement: passo 2, imagem 1 %32 Ryobi RJ1861V Saw Bar Assembly Replacement: passo 2, imagem 2 %32

    • Remove the rubber sleeve.

    • You may have to use some force as it has a tight fit.

    Editar

  3. Ryobi RJ1861V Saw Bar Assembly Replacement: passo 3, imagem 1 %32

    • Use a Torx T5 screwdriver to remove the six screws on the underside of the device.

    Editar

  4. Ryobi RJ1861V Saw Bar Assembly Replacement: passo 4, imagem 1 %32

    • Use a Torx T5 screwdriver to remove the four screws on the top of the gear case.

    • There are two screws on each side of the device.

    Editar

  5. Ryobi RJ1861V Saw Bar Assembly Replacement: passo 5, imagem 1 %32

    • Remove the backside panel.

    Editar

  6. Ryobi RJ1861V Saw Bar Assembly Replacement: passo 6, imagem 1 %32

    • Unscrew the four T5 Torx screws that hold the assembly bar in place.

    Editar

  7. Ryobi RJ1861V Saw Bar Assembly Replacement: passo 7, imagem 1 %32

    • Lift the assembly bar up and out of the chassis.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 11

Últimos 30 dias: 36

Duração total: 881