Ir para o conteúdo principal

Ryobi RJ1861V Assembly Bar Bearing Replacement

O que você precisa

  1. Ryobi RJ1861V Assembly Bar Bearing Replacement, Saw Bar Assembly: passo 1, imagem 1 %32
    • Use a Torx T5 screwdriver to remove the single 8 mm screw securing the shoe.

  2. Ryobi RJ1861V Assembly Bar Bearing Replacement: passo 2, imagem 1 %32 Ryobi RJ1861V Assembly Bar Bearing Replacement: passo 2, imagem 2 %32
    • Remove the rubber sleeve.

    • You may have to use some force as it has a tight fit.

  3. Ryobi RJ1861V Assembly Bar Bearing Replacement: passo 3, imagem 1 %32
    • Use a Torx T5 screwdriver to remove the six screws on the underside of the device.

  4. Ryobi RJ1861V Assembly Bar Bearing Replacement: passo 4, imagem 1 %32
    • Use a Torx T5 screwdriver to remove the four screws on the top of the gear case.

    • There are two screws on each side of the device.

  5. Ryobi RJ1861V Assembly Bar Bearing Replacement: passo 5, imagem 1 %32
    • Remove the backside panel.

  6. Ryobi RJ1861V Assembly Bar Bearing Replacement: passo 6, imagem 1 %32
    • Unscrew the four T5 Torx screws that hold the assembly bar in place.

  7. Ryobi RJ1861V Assembly Bar Bearing Replacement: passo 7, imagem 1 %32
    • Lift the assembly bar up and out of the chassis.

  8. Ryobi RJ1861V Assembly Bar Bearing Replacement, Assembly Bar Bearing: passo 8, imagem 1 %32
    • Begin with the top of the device facing up.

  9. Ryobi RJ1861V Assembly Bar Bearing Replacement: passo 9, imagem 1 %32
    • Insert needle nose pliers to remove the retaining pin at the top of the bearing.

  10. Ryobi RJ1861V Assembly Bar Bearing Replacement: passo 10, imagem 1 %32
    • Once the retaining pin has been removed, pull off the damaged bearing and insert a new one.

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas executaram este guia.

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 9

Duração total: 417