Before disassembling the blender base, make sure the blender disconnected from any power outlet. Lift the jar straight up from the base without tilting the jar.
  • Before disassembling the blender base, make sure the blender disconnected from any power outlet.

  • Lift the jar straight up from the base without tilting the jar.

Adicionar comentário

Remove the top three 1/4 inch base screws using a Philip's head screwdriver.
  • Remove the top three 1/4 inch base screws using a Philip's head screwdriver.

Adicionar comentário

Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver. This provides access to the base screws beneath.
  • Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.

  • This provides access to the base screws beneath.

Adicionar comentário

Remove the following screws that secure the top and  bottom halves of the base.
  • Remove the following screws that secure the top and bottom halves of the base.

    • One 1/4 Phillips screw

    • One TA-20 screw

  • Both screwdrivers must have a minimum of a three inch shank (length).

  • Screwdrivers with extenders will not fit down the access holes.

Adicionar comentário

Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.
  • Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

Adicionar comentário

Tug on wires in the marked locations to make sure they are secure.
  • Tug on wires in the marked locations to make sure they are secure.

  • If the wire stays still, the connection is secure.

    • If you still have problems with the blender, it is probably a problem with the motor. Since the motor is irreplaceable, you will have to order a new blender.

Adicionar comentário

If the wire comes off, the connection is insecure. You will need to solder the connection to make it solid again.
  • If the wire comes off, the connection is insecure. You will need to solder the connection to make it solid again.

  • If you don't know how to solder, here is a link to show you how. http://www.aaroncake.net/electronics/sol...

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

4 outras pessoas concluíram este guia.

Elmer Pres Urbano

Member since: 05-10-2012

142 reputação

Autoria de 1 guia

Equipe

Cal Poly, Team 6-34, Regan Fall 2012 Membro de Cal Poly, Team 6-34, Regan Fall 2012

CPSU-REGAN-F12S6G34

4 Membros

6 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 4

Últimos 30 dias: 28

Todo: 2,293