Introdução

This guide will give a step by step procedure of how to remove and replace the front and back covers of the Canon PowerShot A550.

  1. Unscrew  a total of 6 4.45 mm phillips head screws using a #00 phillips head screwdriver.
    • Unscrew a total of 6 4.45 mm phillips head screws using a #00 phillips head screwdriver.

    • There are 2 screws on the left side (when looking at the front of the camera).

    • There are 3 screws on the bottom

    • There is 1 screw on the right side

  2. Turn to the bottom of the camera.
    • Turn to the bottom of the camera.

    • Open the memory card cover by sliding the "CARD/BATT." button up, and then pulling the cover to the left.

    • This is what the SD card/battery compartment looks like when opened.

    • Remove one 4.45mm phillips head screw from the SD card/battery compartment using a #00 phillips head screwdriver.

    • Gently remove the front cover away from the camera body.

    • Tip: Start by loosening the teeth on the left side of the camera next to the battery compartment.

    • The camera should look like this once the front cover is removed.

    • Start from the battery compartment and remove the back cover.

    • Caution: Do not tug on the back cover after it is removed. This could tear the ribbon attaching the back cover to the camera body.

    • Remove the connecting ribbon from the body of the camera using a pair of tweezers.

    • Once the ribbon connecting the back cover is removed, the back of the camera body should look like this.

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

Shaelyn Thomas

Member since: 19-04-2011

287 reputação

4 Guides authored

Equipe

Cal Poly, Team 8-6, Regan Spring 2011 Membro de Cal Poly, Team 8-6, Regan Spring 2011

CPSU-REGAN-S11S8G6

4 Membros

15 Guides authored

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 6

Todo: 3,428