Pular para o conteúdo principal

Introdução

This guide will explain in depth how to tear down the clock up until the removal, and replacement of the display. In order to take get to the display the speaker must be removed.

  1. Push down on the clip to release pressure. The pull off the plastic cover. Push down on the clip to release pressure. The pull off the plastic cover.
    • Push down on the clip to release pressure. The pull off the plastic cover.

  2. Remove  the 9-volt battery from the battery terminal.
    • Remove the 9-volt battery from the battery terminal.

  3. Take out the six screws located on the back of the device.
    • Take out the six screws located on the back of the device.

    • The red screws are 10 mm Phillip's #1. The orange screws are 13 mm Phillips #1.

    • Three screws are located on the back panel. One is located inside the battery carriage.

    • Two screws are located on the on the back panel on the bottom left and right side.

  4. Remove the 10 mm Phillip's #1 screw. Then remove the metal reinforcement. Then remove the metal reinforcement.
    • Remove the 10 mm Phillip's #1 screw.

    • Then remove the metal reinforcement.

  5. PC Laptop Batteries

    An easy fix for a big power boost.

    Comprar agora

    PC Laptop Batteries

    An easy fix for a big power boost.

    Comprar agora
  6. Using flathead screwdriver undo the release tabs. Using flathead screwdriver undo the release tabs.
    • Using flathead screwdriver undo the release tabs.

  7. Pry the release tabs with a spudger. Start with back of the device on the topside. Start with back of the device on the topside.
    • Pry the release tabs with a spudger.

    • Start with back of the device on the topside.

  8. Pry open both tabs to remove the topside of the clock. Pry open both tabs to remove the topside of the clock.
    • Pry open both tabs to remove the topside of the clock.

  9. Remove the two 10mm Phillip's #1 screws. Also remove the two reinforcements holding the speaker in place.
    • Remove the two 10mm Phillip's #1 screws. Also remove the two reinforcements holding the speaker in place.

  10. Remove the two 10 mm Phillip's #1 screws.
    • Remove the two 10 mm Phillip's #1 screws.

  11. Remove the gray panel from the frame.
    • Remove the gray panel from the frame.

  12. The two latches located in the picture will help take off the display. Remove the display. Remove the display.
    • The two latches located in the picture will help take off the display.

    • Remove the display.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Myles Waiters

Membro desde: 22-09-2014

346 reputação

3 Guias de autoria

Equipe

USF Tampa, Team 10-5, Brown Fall 2014 Membro de USF Tampa, Team 10-5, Brown Fall 2014

USFT-BROWN-F14S10G5

3 Membros

5 Guias de autoria

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 2

Todo: 160