Ir para o conteúdo principal

Protocol TerraCopter EVO Drone Motor Replacement

O que você precisa

  1. Protocol TerraCopter EVO Drone Motor Replacement, Drone Motor: passo 1, imagem 1 %32
    • Orientate the drone to where the black side of the drone face upwards.

    • On the bottom side of the drone, remove the twenty-two 5mm Phillips #1 screws holding the black frame to the body.

    • There is one screw under the rear light. Pry the opaque cover to access the last screw.

  2. Protocol TerraCopter EVO Drone Motor Replacement: passo 2, imagem 1 %32
    • The plastic frames are subject to cracking.

    • Wires run through both frames.

    • Pry the white body away from the black frame.

  3. Protocol TerraCopter EVO Drone Motor Replacement: passo 3, imagem 1 %32
    • Gently pry the motor from it's socket.

  4. Protocol TerraCopter EVO Drone Motor Replacement: passo 4, imagem 1 %32 Protocol TerraCopter EVO Drone Motor Replacement: passo 4, imagem 2 %32
    • Locate these solder points of the leads on the motherboard.

    • From the front of the drone, the left motor has red and blue leads.

    • From the front of the drone, the right motor has white and black leads.

    • Remove the leads from their points on the motherboard with a soldering iron, respective to each motor.

    • Check out our How to Solder and Desolder Connections guide if you are unfamiliar with soldering practices.

Conclusão

To reassemble your device, follow these instructions in reverse order.

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 1

Duração total: 189