Ir para o conteúdo principal

Protocol Galileo Stealth Housing Replacement

O que você precisa

  1. Protocol Galileo Stealth Housing Replacement, Propeller: passo 1, imagem 1 %32
    • Remove the chrome shaft cover by lightly pulling it away from the drone.

  2. Protocol Galileo Stealth Housing Replacement: passo 2, imagem 1 %32
    • Using a Phillips #000 screwdriver, remove the 7mm screw from the propeller stop.

    • Be sure to apply adequate pressure when removing the screw to prevent stripping it out.

  3. Protocol Galileo Stealth Housing Replacement: passo 3, imagem 1 %32
    • Remove the propeller stop from shaft by lightly pulling it away from the drone.

  4. Protocol Galileo Stealth Housing Replacement: passo 4, imagem 1 %32
    • Remove the propeller from shaft by lightly pulling it away from the drone.

  5. Protocol Galileo Stealth Housing Replacement, Housing: passo 5, imagem 1 %32 Protocol Galileo Stealth Housing Replacement, Housing: passo 5, imagem 2 %32
    • Remove the 8mm long Phillips #0 screws (24 total) from the lower housing unit.

    • Take care to place the screws in a safe place to prevent losing them.

  6. Protocol Galileo Stealth Housing Replacement: passo 6, imagem 1 %32
    • Separate the upper and lower housing units by lightly pulling the two housing units apart.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Matthew Selting

Membro desde: 02/15/18

432 Reputação

Autoria de 4 guias

Equipe

UW Stout, Team S8-G4, Ogden Spring 2018 Membro de UW Stout, Team S8-G4, Ogden Spring 2018

UWSTOUT-OGDEN-S18S8G4

Membros da 4

Autoria de 6 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 124