Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Peças

Nenhum componente especificado.

  1. Use the flat end of a spudger to pry the sound card ribbon cable connector up off the logic board.
    • Use the flat end of a spudger to pry the sound card ribbon cable connector up off the logic board.

    • Move the sound card ribbon cable away from the face of the hard drive.

    • It is not necessary to disconnect the sound card ribbon cable from the sound card.

  2. Use the flat end of a spudger to pry the hard drive ribbon cable connector up off the logic board.
    • Use the flat end of a spudger to pry the hard drive ribbon cable connector up off the logic board.

  3. Remove the following four screws: Three 11.1 mm T8 Torx.
    • Remove the following four screws:

    • Three 11.1 mm T8 Torx.

    • One 3.9 mm T8 Torx.

    • Lift the hard drive out of the lower case.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 2

Duração total: 1,276