Introdução

Installing Modem involves removing the outer case and video card before installation.

Peças

Não são necessárias peças.

Release the back handle of the PowerMac. Slowly pull out the cube by holding the end of the handle. Watch for any parts that may become entangled with the outer case.
  • Release the back handle of the PowerMac. Slowly pull out the cube by holding the end of the handle. Watch for any parts that may become entangled with the outer case.

  • Push back the handle after you have taken the core out of the case.

Adicionar comentário

Place the cube upside down and remove the four T10 Torx screws on the front plate. Then remove the two screws on each side.
  • Place the cube upside down and remove the four T10 Torx screws on the front plate. Then remove the two screws on each side.

Adicionar comentário

  • Slowly lift the plate off the cube and disconnect the power cord.

Adicionar comentário

  • Remove the four pillars from each corner.

  • The pillars should come out fairly easily.

If the Cube has an Airport card installed, it must be removed. This can be accomplished by disconnecting its antenna, and pulling gently on the clear plastic tab on its end. The bracket it is contained in must be unlatched from the frame and rotated out of the way to get to the two optical drive mounting screws beneath it.

olearydq - Responder

There is a ribbed cooling plate attached to the hard drive that must be removed before step 7.

isitism - Responder

There is no need to remove the four pillars. Skip step 4. In step 5, don't turn the Cube on it's side. The Airport slot swings out like a door, providing access to the IDE ribbon and power cables to complete step 6. Complete steps 6 and 7 while the cube is upright.

timhood - Responder

  • Remove the screws on the back of the VGA port.

Adicionar comentário

  • Remove the screw attaching the video card to the logic board.

Adicionar comentário

  • Remove power cord from the video card.

Adicionar comentário

  • Remove the power cord.

  • Remove the connector.

  • Remove the video card from the logic board.

Adicionar comentário

  • Carefully lift the video card from the logic board.

  • The video card should come out easily.

Adicionar comentário

  • Separate the video card from the adapter.

Adicionar comentário

  • Remove the two screws from the modem.

Adicionar comentário

  • Lift modem from the Logic Board.

  • The modem should come out easily.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Ryan Chun

Member since: 24-06-2010

674 reputação

7 Guides authored

Equipe

Cal Poly, Team 2-7, Johann Summer 2010 Membro de Cal Poly, Team 2-7, Johann Summer 2010

CPSU-JOHANN-R10S2G7

5 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 4

Últimos 30 dias: 8

Todo: 3,546