Introdução

This guide will teach the reader how to install a new case of the camera. If the case on the camera gets cracked or is starting to come apart, this guide will help to replace it with a new case.

Peças

Não são necessárias peças.

Flip the camera over so the bottom is facing you. Flip the camera over so the bottom is facing you.
  • Flip the camera over so the bottom is facing you.

Adicionar comentário

Open the cover on the bottom by sliding it in the direction of the arrow. Open the cover on the bottom by sliding it in the direction of the arrow.
  • Open the cover on the bottom by sliding it in the direction of the arrow.

Adicionar comentário

Remove the batteries by pulling up on the top with your fingers.
  • Remove the batteries by pulling up on the top with your fingers.

Adicionar comentário

Unless otherwise stated, use a phillips #00 screwdriver to remove screws.
  • Unless otherwise stated, use a phillips #00 screwdriver to remove screws.

  • Remove the two 4.70mm screws in the bottom of the plastic casing.

Adicionar comentário

Remove the four 4.70mm screws in the left side of the camera. Remove the four 4.70mm screws in the left side of the camera.
  • Remove the four 4.70mm screws in the left side of the camera.

Adicionar comentário

Now on the side with the strap, remove the other four 4.70mm screws. Now on the side with the strap, remove the other four 4.70mm screws.
  • Now on the side with the strap, remove the other four 4.70mm screws.

Adicionar comentário

Use your thumbs to pry the case apart. It is easiest to pry to case apart if your start at the bottom. The case should come apart with minimal effort. If  it doesn't, you can use a tool such as a Spudger or Plastic Opening tool.
  • Use your thumbs to pry the case apart.

  • It is easiest to pry to case apart if your start at the bottom.

  • The case should come apart with minimal effort. If it doesn't, you can use a tool such as a Spudger or Plastic Opening tool.

Adicionar comentário

This step requires a significant amount of force.
  • This step requires a significant amount of force.

  • Pull the bottom half of the inner camera out of case about half an inch. This may be difficult and force is necessary.

Adicionar comentário

While pulling the camera out of the case, note the small soft plastic cover on the side of the camera. This cover will detach from the rest of the device. Once the bottom of the inner camera is pulled out about an inch and a half, pull the device out completely.
  • While pulling the camera out of the case, note the small soft plastic cover on the side of the camera. This cover will detach from the rest of the device.

  • Once the bottom of the inner camera is pulled out about an inch and a half, pull the device out completely.

  • When completely removing the device from the case, use a firm grasp with your hands for stability and control.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Clay Young

Member since: 04-04-2012

191 reputação

2 Guides authored

Equipe

Cal Poly, Team 15-13, Forte Spring 2012 Membro de Cal Poly, Team 15-13, Forte Spring 2012

CPSU-FORTE-S12S15G13

5 Membros

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 3

Últimos 30 dias: 8

Todo: 1,284